Tip: Alternative to C-frame dimpler

[Boomer506]

This is my second build project and I never did purchase a C-frame dimpler/riveter. I built a bucking bar/die holder into my work table so that the male dimple die is flush with the table pad. I can then use my female swivel dimple set and quickly dimple large skins and many other parts.

 

[krw5927]

A fine idea, and can leave one hand free to position the skin. Nice!

 

[pappa]

This is my second build project and I never did purchase a C-frame dimpler/riveter. I built a bucking bar/die holder into my work table so that the male dimple die is flush with the table pad. I can then use my female swivel dimple set and quickly dimple large skins and many other parts.

Where did you get the swivel dimple set, or did you make it

 

[Boomer506]

I think it was from Aircraft Tool Supply. But I bought it when I started my first project which was 25 years ago! But I bet you could still find one and from multiple sources. I use the heck out of that thing.

 

[Kent Ashton]

Great idea. All you need is a small laser or spot of light shining down to help put the hole over the male die