tikicarver
Well Known Member
My tail spring will not slide into the weldment. seems like the inside diameter of the weldment is just about .001 or .002 smaller than the OD of the tail spring.
I thought about borrowing a reamer to clean up the hole but someone pointed out since there are two bushings in the tube on opposite ends, if the reamer goes in at a slight angle it will not line up on the opposite side bushing.
I'm interested to hear how other people got a nice fit of the tail spring into the weldment.
I thought about borrowing a reamer to clean up the hole but someone pointed out since there are two bushings in the tube on opposite ends, if the reamer goes in at a slight angle it will not line up on the opposite side bushing.
I'm interested to hear how other people got a nice fit of the tail spring into the weldment.