istrumit
Well Known Member
I am planning to glue a couple of drilled rivet heads to the static ports to cure a low IAS calibration (see my previous threads on this).
After experimenting with layered duct tape, it is time for the next step, actually attaching drilled rivet heads.
But, in case it doesn't work, i need to be able to easily remove them using some sort of glue solvent that won't damage the paint.
Any recommendations on glue type (and solvent if needed).
Thank you,
Scott
After experimenting with layered duct tape, it is time for the next step, actually attaching drilled rivet heads.
But, in case it doesn't work, i need to be able to easily remove them using some sort of glue solvent that won't damage the paint.
Any recommendations on glue type (and solvent if needed).
Thank you,
Scott