BGordon
Well Known Member
Evening everyone,
I am working on my slider canopy roller track ( C-657) and trying to cut the notch in the rear. The plans say the notch should start 1 3/8" in, and that the picture is drawn to full scale (DWG 41). However the measurements show 11/16" even though the drawing is the width as the track bar. Either the measurement is wrong or the picture is not full scale. Any ideas?
Thanks
B
I am working on my slider canopy roller track ( C-657) and trying to cut the notch in the rear. The plans say the notch should start 1 3/8" in, and that the picture is drawn to full scale (DWG 41). However the measurements show 11/16" even though the drawing is the width as the track bar. Either the measurement is wrong or the picture is not full scale. Any ideas?
Thanks
B