Hello!
I Think I might be almost ready to rivit on my canopy skirts...finally! Most folks I know however have taken the Sika adhesive route and so Im posting this before I jump to it.
First, Any warnings for drilling out the cs4-4 pop rivits that were used to hold canopy in place during the fitting of the skirt process? Im concerned that the pop rivit will spin or something and then ILL have greater difficulty getting it out. I also know I may need to push the back end of rivit free into the frame tube. How best should that be done?
Second, Should I use weather adhesive along top inside lip before I rivit or can a bead be applied after along the edge? What do most rivited canopy to skirt builds have??
Any advice will be appreciated.
ThankYou!!
I Think I might be almost ready to rivit on my canopy skirts...finally! Most folks I know however have taken the Sika adhesive route and so Im posting this before I jump to it.
First, Any warnings for drilling out the cs4-4 pop rivits that were used to hold canopy in place during the fitting of the skirt process? Im concerned that the pop rivit will spin or something and then ILL have greater difficulty getting it out. I also know I may need to push the back end of rivit free into the frame tube. How best should that be done?
Second, Should I use weather adhesive along top inside lip before I rivit or can a bead be applied after along the edge? What do most rivited canopy to skirt builds have??
Any advice will be appreciated.
ThankYou!!