So I'm putting on KN HP-1002 oil filter instead of NAPA Gold 1515 because I don't have the experience and comfort not safety wiring even though I see very seasoned builders saying its ok for oil filters not to safety wire. But what about oil temperature sensor? When I removed the old straight oil filter adapter and installed a Casper 90 deg adapter and spacer, I could not reuse the older Lycoming sensor (damaged electrical area). Dynon included a new one in their EMS kit but its not drilled for safety wiring. Are we not safety wiring the oil temp sensors anymore either? This is freaking me out. I'll probably just drill it but wondering if its now acceptable to not wire it. I mean 180 turn on a crush washer doesn't seem enough. Just sayin....