I have searched the forum. I have called Van's support ( not a real definitive answer).
Soo I need some help.
I am running a lot of wires down the inside of my left gear tower. I need to exit them near the bottom in the same area that already has holes for fuel lines. ( there are two and both are used). The Right Gear tower has a huge hole (at least an inch). Form many reasons I cannot run all my wires on that side.
1. Can I drill an addition two 3/4 inch holes in that area?
2. Has anyone else done this?
3. What should the spacing be?
I can easily keep 3/4 " spacing between the edges of all holes if that info helps.
Soo I need some help.
I am running a lot of wires down the inside of my left gear tower. I need to exit them near the bottom in the same area that already has holes for fuel lines. ( there are two and both are used). The Right Gear tower has a huge hole (at least an inch). Form many reasons I cannot run all my wires on that side.
1. Can I drill an addition two 3/4 inch holes in that area?
2. Has anyone else done this?
3. What should the spacing be?
I can easily keep 3/4 " spacing between the edges of all holes if that info helps.