Lucio I-NLCM
Active Member
Yesterday , the 16th November , here in Italy at Trento airport LIDT in late morning on runway 36, the standard and GREAT kit serial # 71804 took off becoming an amazing RV-7 , the I-NLCM.
The baby is equipped :
-Engine Lyco IO 360 A1A angle valve 200 hp overhauled
-Three bladed CATTO prop
-Dual P-Mag + ECI
-Dynon : SV1000 , Knob Control panel , full AP with control panel, VHF Com (2) Radio, EMS , Transponder Mode "S", AOA Pitot, GPS receiver.
-Garmin 695
- Becker AR-6201 Com (1) @ 8.33
- Winter ALT and ASI
- ELT Artex
- Power Flarm
First of all, my biggest thanks to Cinzia , patient and caring wife , pillar of encouragement ; and to Camy, brightly and essential shop helper, our always smiling daughter .
I'd like give my public thanks to Luca Perazzolli friend and councillor passionate..... as well as first flight ground support.
For friends Walter, Franz, Giordano, Luca, Daniele, Roberto and others beside them, thanks a lot at all for your encouragement.
Thank you Joe , and at all Van's staff.
Last but not least, thank you Doug, without your forum and all friends met here, the project would have been possible.
http://YouTube.com/watch?v=z6RBljqmlkg
The baby is equipped :
-Engine Lyco IO 360 A1A angle valve 200 hp overhauled
-Three bladed CATTO prop
-Dual P-Mag + ECI
-Dynon : SV1000 , Knob Control panel , full AP with control panel, VHF Com (2) Radio, EMS , Transponder Mode "S", AOA Pitot, GPS receiver.
-Garmin 695
- Becker AR-6201 Com (1) @ 8.33
- Winter ALT and ASI
- ELT Artex
- Power Flarm
First of all, my biggest thanks to Cinzia , patient and caring wife , pillar of encouragement ; and to Camy, brightly and essential shop helper, our always smiling daughter .
I'd like give my public thanks to Luca Perazzolli friend and councillor passionate..... as well as first flight ground support.
For friends Walter, Franz, Giordano, Luca, Daniele, Roberto and others beside them, thanks a lot at all for your encouragement.
Thank you Joe , and at all Van's staff.
Last but not least, thank you Doug, without your forum and all friends met here, the project would have been possible.
http://YouTube.com/watch?v=z6RBljqmlkg