Hello all,
The fibreglass tip is somewhat sealed at the aft point thus not allowing the trailing edge wedge to fit inside the tip.
I would cut the last 1/2 inch of the tip flush with the edge of the skin but id rather keep the step cast in the fibreglass all the way to the end at least an 1/8 to 1/4" deep under the skins
Can I trim the trailing edge wedge to accommodate this? Again approx 1/4 from the edge of the skin.
The wedge isn't riveted in yet so now is the time and I'm just looking ahead
Thoughts?
The fibreglass tip is somewhat sealed at the aft point thus not allowing the trailing edge wedge to fit inside the tip.
I would cut the last 1/2 inch of the tip flush with the edge of the skin but id rather keep the step cast in the fibreglass all the way to the end at least an 1/8 to 1/4" deep under the skins
Can I trim the trailing edge wedge to accommodate this? Again approx 1/4 from the edge of the skin.
The wedge isn't riveted in yet so now is the time and I'm just looking ahead
Thoughts?