alpinelakespilot2000
Well Known Member
Elevator Control Horn Problem?
In my emp. kit, my elevator control horns seem to have incomplete welds. The weld goes most of the way around the ~1" tube where it meets the horn, but there is about a 3/16-4/16" gap where there is no weld. I seem to remember others saying theirs were like this earlier on some forum, but can't remember what the conclusion was. Is this how everyone's are or is this something I should have Van's replace?
Thanks,
Steve
In my emp. kit, my elevator control horns seem to have incomplete welds. The weld goes most of the way around the ~1" tube where it meets the horn, but there is about a 3/16-4/16" gap where there is no weld. I seem to remember others saying theirs were like this earlier on some forum, but can't remember what the conclusion was. Is this how everyone's are or is this something I should have Van's replace?
Thanks,
Steve
Last edited: