logansc
Well Known Member
I am replacing the rudder cables on my Rocket in order to eliminate the mid-cable rear seat rudder pedal connectors. I'm ready to swage on new stainless steel forks at the (rear) rudder horns and am wondering if there are any general rules about how much slack there should be in the cable runs.
I'll just "wing it" if no one has any specific suggestions, but I know I've never seen any Rocket or RV cables that were actually taunt. I figure something like an inch or so of play will be about right, but I'm wondering if there is any general "rule of thumb" I should go by.
Regards,
Lee...
I'll just "wing it" if no one has any specific suggestions, but I know I've never seen any Rocket or RV cables that were actually taunt. I figure something like an inch or so of play will be about right, but I'm wondering if there is any general "rule of thumb" I should go by.
Regards,
Lee...