AX-O
Well Known Member
So I have been looking for an iPad mini knee board for a couple of weeks. Santa was nice to me and the iPad showed up unannounced. As some of you may know, there are few products out there supporting the mini. The knee board products that are out there are few and expensive. And on top of that are not as simple as I want them to be. So I started thinking about rolling my own. This is what I did.
I went to store X and bought a plastic iPad cover.
I took my nine-g knew board out and measured it. Compared the paper checklist to the iPad.
I then laid the plastic strap over the iPad cover and marked it. Then to the cutting board.
Back to my 9-g knee board and voila! It took me longer to write this up than to roll my own knee board. Total cost was $20. It was simple, light, elegant and hopefully functional. I can stand up and the iPad remains on the knee board.
Hope to fly it this weekend. I should trade mark this or something. Way too easy to do and someone will probably see this post and mass produce it.
I went to store X and bought a plastic iPad cover.
I took my nine-g knew board out and measured it. Compared the paper checklist to the iPad.
I then laid the plastic strap over the iPad cover and marked it. Then to the cutting board.
Back to my 9-g knee board and voila! It took me longer to write this up than to roll my own knee board. Total cost was $20. It was simple, light, elegant and hopefully functional. I can stand up and the iPad remains on the knee board.
Hope to fly it this weekend. I should trade mark this or something. Way too easy to do and someone will probably see this post and mass produce it.