tc1234c
Well Known Member
I am sure that no one made the dumb mistake I did. Just in case anyone did, my experience may save you. Yesterday I got an email from a 6A builder telling me that he saw my 9A at MERFI on Sunday and found my flap push rod end bearings were installed wrong (see picture below):
When I think about it, it is so clear what the problem was. But I did not catch it over the past 230 hrs. My FSDO inspector did not catch it a year ago neither. I am grateful to Tony for his keen observation. It might have saved my life if one of the rod end bearings fails.
This morning I spent an hour correcting the problem and test flown the airplane. The bearings are still in good shape without any free play. Here is the correct installation:
(new picture. Blue loctit on threads, lock washer added. Washer above the jam nut to be removed.)
Check your installation and make sure you did not make the same mistake I made.
![oldFlapRodend.jpg](/proxy.php?image=http%3A%2F%2Ftc1234c.googlepages.com%2FoldFlapRodend.jpg&hash=eedd1c5beb34bb1e28f0788845248c3f)
When I think about it, it is so clear what the problem was. But I did not catch it over the past 230 hrs. My FSDO inspector did not catch it a year ago neither. I am grateful to Tony for his keen observation. It might have saved my life if one of the rod end bearings fails.
This morning I spent an hour correcting the problem and test flown the airplane. The bearings are still in good shape without any free play. Here is the correct installation:
![FlapRodend.jpg](/proxy.php?image=http%3A%2F%2Ftc1234c.googlepages.com%2FFlapRodend.jpg&hash=999d2b31b08c6e6c55cb65ebbf1eb9d2)
(new picture. Blue loctit on threads, lock washer added. Washer above the jam nut to be removed.)
Check your installation and make sure you did not make the same mistake I made.
Last edited: