propsync
Well Known Member
Hi Group, just a quick question.
The directions basically say to rivet the top skins to the ribs and then deal with the jchannel.
Although the directions don't state because I guess its obvious, the only way to get the jchannels into the wing at this point would be to slide them in from the root and the tip. This seems problematic to me although I haven't riveted the skins yet. It seems like a hole lot off scrapin and scratchin will be going on sliding in these jchannels, especially since the jchannel and skins are dimpled at this point.
I'm trying to figure out why not just clecko them in before the riveting gets started. But, maybe there is a reason that I just can't see right now.
I was wondering what those who are past this point have to say about it, thanks.
The directions basically say to rivet the top skins to the ribs and then deal with the jchannel.
Although the directions don't state because I guess its obvious, the only way to get the jchannels into the wing at this point would be to slide them in from the root and the tip. This seems problematic to me although I haven't riveted the skins yet. It seems like a hole lot off scrapin and scratchin will be going on sliding in these jchannels, especially since the jchannel and skins are dimpled at this point.
I'm trying to figure out why not just clecko them in before the riveting gets started. But, maybe there is a reason that I just can't see right now.
I was wondering what those who are past this point have to say about it, thanks.