rookie1255
Member
Morton Buildings
60'x104'x16'=6240 sq ft pole barn
R-19 in walls and R-38 blown in insulation in the ceiling
Basic lighting circuits and outlets
Cost: 186k, 30k of that is a hydroswing door. Comes out to $30 a sq ft. Does this seem reasonable?
Not included
Site prep
Concrete slab
Radiant floor heat (pex, boiler, etc)
Tap off existing well and tie into existing septic
Plumbing stub outs for kitchen and bath
I'd also like to add a large overhead door on the other side large enough to fit an RV/Boat. Epoxy floor later on when funds available. Do the kitchen and bath work myself one day. I considered having the amish do the pole barn since I hear good things about their work, but I'm not confident about their knowledge of hydroswing doors, boilers and radiant heat, etc...
60'x104'x16'=6240 sq ft pole barn
R-19 in walls and R-38 blown in insulation in the ceiling
Basic lighting circuits and outlets
Cost: 186k, 30k of that is a hydroswing door. Comes out to $30 a sq ft. Does this seem reasonable?
Not included
Site prep
Concrete slab
Radiant floor heat (pex, boiler, etc)
Tap off existing well and tie into existing septic
Plumbing stub outs for kitchen and bath
I'd also like to add a large overhead door on the other side large enough to fit an RV/Boat. Epoxy floor later on when funds available. Do the kitchen and bath work myself one day. I considered having the amish do the pole barn since I hear good things about their work, but I'm not confident about their knowledge of hydroswing doors, boilers and radiant heat, etc...
Last edited: