Thanks for the advice gents! I was reading the Aeroelectric Connection before my life got taken over by the engine overhaul. Are internally regulated alternators preferred or externally regulated? Thanks Again.
Bob of AeroElect clearly prefers external. His reason is the "dreaded" over voltage, which Bob tends to fear monger a little with. The internal is easier to wire and very reliable as well. However if you are serious IFR........ and you already have an externally regulated alternator, than that might be best, but you do have options.
First of all what alternator is that? It is NOT the typical NipponDenso that Van supplies with the FWF kit. It looks like a Electro systems / Electodelta / Ford? aircraft alternator:
http://www.aircraftspruce.com/catalog/eppages/fordalts.php
As you can see to exchange it is about $270. That's an option. Forget trying to get an automotive equivalent to match this. $230-$270 does not sound bad but its an old external fan design. Aircraft rebuilds have to have better QC than the auto-electric re-builders, but read the Plane Power web site for all the reasons to switch.
If you decide to switch, Plane Power can save same weight. Also they may make a little more real power, run cooler and save a few HP in less drag. If you already have an external regulator you can stick with that. You can always add Bobs OV crow bar device ir upgrade to a modern external regulator (Transpo 1200V, see below). Plane Power makes very nice alternators both internal and externally regulated. The internal ones already have "Extra" OV protection circuit that makes Bob happy, belt and suspenders. So there is absolutly no advantage with going external with plane power, however if you are already external it might be easier to stay that way. If you switch FROM externally regulated to internal voltage regulation, you will have to some re-wiring, but you are actually going from more wires to less wires. Plus you can get rid of the external regulator (if you have one).
If get a Plane Power external regulator alternator you could use the current regulator. I have no idea what voltage regulator you have, if you have one. If it's the case, than it might be a good to replace the regulator. External regulation is not automatically over-voltage proof or protected. If your current regulator has no OV protection, you can add an OV device on to an existing external regulator. You can also replace it with a regulator that has the OV protection built in. B&C voltage regulators, have an OV built-in. The B&C cost about $230, BUT MY ADVICE (if you stay with external volt reg) is buy a Transpo 1200V solid state voltage regulator with OV protection. Transpo 1200V can be purchased at most Auto electric specialty places. Your local auto parts store most likely will not have them stocked, but they may be able to order it for you. Ask them if they have a WAI (Wetherill Associates, Inc.) account, the distributor or Transpo parts. The part number is 1200V and they cost about $70-$80. I assume you have 12 volt but they V1200 comes in both 12 ad 24 volt so specify.
I know if you go with "Plane Power" you will have the best you can get for experimental, which is as good or better than you current unit. It most likely will be a little lighter and run cooler than your current alternator, with good reliability.