Prop Spinner Front Bulkhead Too Large

[JackW794]

I have a Sensenich ground adjustable pitch prop made for high performance Van's aircraft. My problem is that the Sensenich front spinner bulkhead (for the metal prop) from Van's (S-605 SEN) is too large. The spinner lacks about an inch from bottoming out as it should on the rear spinner bulkhead.

I wonder if the Sensenich Front Bulkhead (C2395) for the RVs with 1/2" bolts would work.

Any advice on how to solve this problem is appreciated.

 

[Swingwing]

What diameter do you need? I have an unused one that I probably will never use. You can have it for the cost of shipping

 

[JackW794]

Front Bulkhead Too Large

The front bulkhead I got from Van's is 11.125" OD. So I would need something a bit smaller, but I'm not sure how much would do the trick. I think some kind of spacer could overcome the difference if a bulkhead is a little bit too small.

I'm willing to pay shipping costs if you have one a little smaller than mine.

 

[JackW794]

Front Bulkhead Diameter

My best guesstimate of the bulkhead diameter would be around 10.5".