RidiculousM
Well Known Member
I slipped and fell *** first on the aft corner of the F-827-1 left lower bottom skin. This is the skin that will overlap and be screwed to the left wing on my RV-8.
This did two things, first, it put a pretty good crease on the rivet line, where the red arrows are, it actually stretched and distorted six of the rivets, that's why I removed them. Second, it created an upward bow in the skin along the blue dotted line when it folded over the edge of the fuselage stand.
I'm wondering if I could tap some of it out using a rivet gun and a wood block.
Has anybody replaced one of these skins before?
I know in the end I can primer and fill to fade some of it out but I prefer to not fill rivet heads so any ideas, suggestions, tips would be great.
Thanks,
Mike
This did two things, first, it put a pretty good crease on the rivet line, where the red arrows are, it actually stretched and distorted six of the rivets, that's why I removed them. Second, it created an upward bow in the skin along the blue dotted line when it folded over the edge of the fuselage stand.
I'm wondering if I could tap some of it out using a rivet gun and a wood block.
Has anybody replaced one of these skins before?
I know in the end I can primer and fill to fade some of it out but I prefer to not fill rivet heads so any ideas, suggestions, tips would be great.
Thanks,
Mike