A NTSB report on a PT-22 crash early this year found that the aircraft's shoulder harness retrofit contributed to the pilot's injuries. The attach points of the shoulder straps were lower than the level of his shoulders when seated, which apparently compresses your spine/pelvis when your body is restrained during a sudden deceleration. I have a similar geometry when I am seated in my RV-8. I noticed that some RVs have a tall roll bar that supports the pilot seat - was that the "stock" design at some point? A taller roll bar could allow for the attach points to be moved higher / above shoulder level, and mitigate any deceleration injuries. Could this earlier design be retrofitted, or maybe the existing low bar that supports the pilot's seat be extended by welding an extension?