The RV-14's instructions have been great and I have very few complaints, they did a tremendous job. This is one of those steps I'm not quite understanding "why".
It's calling to undo some rivets and install a blocking plate with some RTV.
Removing the rivets will be challenging based on what's going on in that area but I can manage it no problem. However, beyond that, I'm trying to figure out why we didn't do this when the vents were assembled and also why this modification is being called for.
Any explanation/insight would be appreciated! I may be missing something obvious ...
It's calling to undo some rivets and install a blocking plate with some RTV.
Removing the rivets will be challenging based on what's going on in that area but I can manage it no problem. However, beyond that, I'm trying to figure out why we didn't do this when the vents were assembled and also why this modification is being called for.
Any explanation/insight would be appreciated! I may be missing something obvious ...
Last edited: