Panel marking nice touches.

[rjcthree]

No worries, not 'how should I label my panel' requests. That's done

The question I have before I head to clearcoat the thing is what details have you seen that were nice/wish you had done.

I've gotten the N-number in, emerg canopy release, passenger warning and passenger instructions (seatbelts, don't touch nuttin'), all the breakers, switches with purpose and off conditions.

I flirted with V-speeds and fuel but decided that my checklist card can carry those.

Inspirational is going on the back cabin wall, with EXPERIMENTAL.

tHOUGHTS?

 

[Greg Arehart]

One thing I did was to put my compass correction card as a label stuck to a small piece of Al that is screwed to the panel. I can then just unscrew the piece and put a new label on if/when the deviations change. I did the same thing for my fuse block (but its hidden under the canopy anyway). I learned this because my original labels were done by etching anodized Al and I had to make some changes, thus discarding the etched labels.

Not sure this exactly addresses your question....

greg