Paul the Overlord
Well Known Member
Hello,
After doing all the riveting on page 20-04 Fig 1 an A&P who works here said it looked like I used too short a rivet for the top row for the 470/426 4-8. The rivet gauge confirms this. I measured the rivets to make sure they were correct (they were). All the smart guys here agree the rivet should have been longer, BUT, it's Ok the way it is (drilling out the rivets and replacing would make it worse). Anyone else notice this?
After doing all the riveting on page 20-04 Fig 1 an A&P who works here said it looked like I used too short a rivet for the top row for the 470/426 4-8. The rivet gauge confirms this. I measured the rivets to make sure they were correct (they were). All the smart guys here agree the rivet should have been longer, BUT, it's Ok the way it is (drilling out the rivets and replacing would make it worse). Anyone else notice this?