I'm going through my list of things that need attention prior to my final inspection.
With my nose wheel axle bolt torqued at 10 foot pounds like the instructions say and the washer stack installed to allow the nose pant bracket to slide in as indicated on drawing C1, I've only got about a half thread showing out of the lock nut. I assume the axle bolt is AN6-60a, but my gauge only goes to 50.
Anyone else run into this?
With my nose wheel axle bolt torqued at 10 foot pounds like the instructions say and the washer stack installed to allow the nose pant bracket to slide in as indicated on drawing C1, I've only got about a half thread showing out of the lock nut. I assume the axle bolt is AN6-60a, but my gauge only goes to 50.
Anyone else run into this?