Hi folks,
today I tried to install the Nose Gear Reinforcement Angles F-897. Trouble is, that using the rivet hole in the flange of the firewall as a pilot hole will result in a hole position in F-896 different than in the plans (DWH 61). The hole will end up approx near the center line of F-897. Any ideas what I should do?
Thanks
Thilo
today I tried to install the Nose Gear Reinforcement Angles F-897. Trouble is, that using the rivet hole in the flange of the firewall as a pilot hole will result in a hole position in F-896 different than in the plans (DWH 61). The hole will end up approx near the center line of F-897. Any ideas what I should do?
Thanks
Thilo
