In Van's Notification 15-10-01 the flap actuator force can be reduced by trimming the VA-114 spring by 0.5".
When I cut F-1260A to length of 10 13/16" as described in Section 32, I didn't remember that I already had trimmed the length of the spring. So I ended up in a too short F-1260A flap handle tube.
No big deal to replace that tube, but I am wondering if the KAI should have been updated or why the notification does not mention anything about the fork assembly.
Do I miss anything here?
Thank you !!
When I cut F-1260A to length of 10 13/16" as described in Section 32, I didn't remember that I already had trimmed the length of the spring. So I ended up in a too short F-1260A flap handle tube.
No big deal to replace that tube, but I am wondering if the KAI should have been updated or why the notification does not mention anything about the fork assembly.
Do I miss anything here?
Thank you !!