Mixer Bellcrank Wiring Harness Inteference

[Bob Ross]

Hello RV12ers:

I am currently installing the Skyview Update which involves running quite a few new wires thru the tunnel wiring harness (quite a bit of "cuss'in" in the hangar the last few days!).

Has anyone noticed that the AN4 bolt the goes thru the mixer bellcrank comes very close to hitting the wires and brake lines under it? Has anyone come up with a solution for this?

Regards,

Bob

 

[Bill_H]

Go here. http://tonytessitore.smugmug.com/RV-12Project/. Then click on Finish Kit then go to page 3 for a neat trick using tie wraps for that purpose.