Mistake in -10 plans?

[dhmoose]

I am working on the baffles and was about to rivet the Oil cooler brace (Page FF2-18, step 4) when I noticed the call out for nine AN426AD3-3.5 rivets. Problem is, there are no dimples or countersinks called out prior!

I would like to go ahead and use AN470AD3-4 rivets instead...but does anyone know if that will interfere with anything else? Is this a mistaken call out or did I miss something? For reference to the manual, see the link below:

 

[CharlieWaffles]

What??? A Mistake in the plans??? No!!!!

 

[Jesse]

I dimple and use the called out rivets, flush on the aft side. Makes the scat tube flange and plug wire seals sit flush. Also easier to rivet IMHO.

 

[dhmoose]

Thanks Jesse

Maybe I missed any mention of dimpling in the plans and now, the task would be challenging. A 470 rivet wouldn't interfere with anything as far as I can tell, so I think I'll go rogue and veer from the plans

I appreciate the input though.