tx_jayhawk
Well Known Member
Final fitting the James plenum and carb airbox, and I had a couple of questions I was helping those with the same setup could answer:
1) I have the older (flat squarish) style carb air box. When installed, there is not enough room to install the air box inline between the inlet ring and carb box. What have others done?
2) What type hose are most people using to attach the inlet ring and the air box? I understand that it needs to be some sort of stiff 3" hose...any suggestions?
3) How is the airbox typically supported?
On the plenum...I assume you just wrap the wetsuit material around the plenum to ring intersection and glue it with the supplied glue?
Thanks,
Scott
7A
1) I have the older (flat squarish) style carb air box. When installed, there is not enough room to install the air box inline between the inlet ring and carb box. What have others done?
2) What type hose are most people using to attach the inlet ring and the air box? I understand that it needs to be some sort of stiff 3" hose...any suggestions?
3) How is the airbox typically supported?
On the plenum...I assume you just wrap the wetsuit material around the plenum to ring intersection and glue it with the supplied glue?
Thanks,
Scott
7A