woodsideraff
Well Known Member
I am using a #41 reamer to match "drill" the skins to the inner ribs. I notice that the holes on the skins and ribs in the rudder are already the right size. The rivets go in without match drilling.
I cannot find in the instructions a step for match drilling the skins to the ribs. Is this new for the -14? In the -7 we had to enlarge all the holes.
Any comments?
Cheers,
Rafael
I cannot find in the instructions a step for match drilling the skins to the ribs. Is this new for the -14? In the -7 we had to enlarge all the holes.
Any comments?
Cheers,
Rafael