Lionclaw
Well Known Member
I just received a new Skytronics magneto harness for my d3000 magneto. Inside the cap, one of the white rubber pieces that fit into the magneto is sticking out of the cap about 1/2" and will not allow the cap to properly fit to the magneto.
I tried carefully pushing it back in and gently tugging at the wire from the outside, but it won't pull the rubber piece flush with the inside of the cap.
Is this a common problem, and is there a way to fix it?
I figured I'd check here before calling Skytronics tomorrow.
I tried carefully pushing it back in and gently tugging at the wire from the outside, but it won't pull the rubber piece flush with the inside of the cap.
Is this a common problem, and is there a way to fix it?
I figured I'd check here before calling Skytronics tomorrow.