Jermechanic
Well Known Member
I will be pulling a cylinder from my narrow deck O-320A2B. It has the hex type internal thread cylinder base nuts.
Am I correct in assuming I will need 3 of the cylinder hex wrenches to torque the cylinder properly?
2 of the 1/2" hex cylinder wrenches to properly torque the free-thru studs simultaneously and a single 3/8" hex cylinder wrench as those studs don't pass through to the other side?
Thanks
Jeremy
I think I will need the following three wrenches for the cylinder nuts style shown in the ebay link
https://www.aircraft-tool.com/shop/detail.aspx?id=6494-SET
plus
https://www.aircraft-tool.com/shop/detail.aspx?id=6494-2
https://www.ebay.com/itm/333727340621
Am I correct in assuming I will need 3 of the cylinder hex wrenches to torque the cylinder properly?
2 of the 1/2" hex cylinder wrenches to properly torque the free-thru studs simultaneously and a single 3/8" hex cylinder wrench as those studs don't pass through to the other side?
Thanks
Jeremy
I think I will need the following three wrenches for the cylinder nuts style shown in the ebay link
https://www.aircraft-tool.com/shop/detail.aspx?id=6494-SET
plus
https://www.aircraft-tool.com/shop/detail.aspx?id=6494-2
https://www.ebay.com/itm/333727340621