JwWright57
Well Known Member
Hey guys I’m having an intermittent Lane A fault on my 912iS.
When i first did my install i couldn’t get the Lane A fault light to go off. I removed the connector at the back of the ignition module, double checked all the pins and reinserted it. That seemed to fix the problem. I did my first engine start, including the Lane A, B check. It was all good. Then today (about a week and a half later) I’m getting the same **** fault light. Turn on Lane A and it cycles and then the red rotax warning to land pops up. Just Lane A, Lane B has always worked.
Any suggestions?
When i first did my install i couldn’t get the Lane A fault light to go off. I removed the connector at the back of the ignition module, double checked all the pins and reinserted it. That seemed to fix the problem. I did my first engine start, including the Lane A, B check. It was all good. Then today (about a week and a half later) I’m getting the same **** fault light. Turn on Lane A and it cycles and then the red rotax warning to land pops up. Just Lane A, Lane B has always worked.
Any suggestions?