Pardon the dumb question. I'm probably going to professionally alodine the interior parts. I would have sharpied the parts numbers onto each part as I remove the blue plastic but I realized the prep will probably dissolve all that marking.
I was considering stamping the parts which is more than a bit cumbersome. Tagging would be equally cumbersome of course and may not survive either. Is there suggested means to maintain identification of internal parts through the prep and alodine process??
Thanks for your suggestions.
Michael B.
I was considering stamping the parts which is more than a bit cumbersome. Tagging would be equally cumbersome of course and may not survive either. Is there suggested means to maintain identification of internal parts through the prep and alodine process??
Thanks for your suggestions.
Michael B.