logansc
Well Known Member
I'm installing a new AFS/Dynon AOA-enabled pitot on my 7 year old Rocket. There does not seem to be an obvious way to string the additional pitot tube and wiring necessary through a long finished wing with only two small inspection plates. Complicating matters is the fact that Rocket wings fit pretty tightly to the fuselage with little space between the two. My wingtip antenna, landing light, strobe, etc wires were strung in the open through small rib holes with plastic grommet inserts. They are ty-wrapped by not otherwise protected or inside a conduit. Nevertheless that route is full with no more room (don't see how I could use them anyway.
Anyhow, long story short, has anyone figured out a safe/suitable/clever way to get the new lines (pitot and signal) out through the wing to the new pitot?
Thanks!
Lee...
Anyhow, long story short, has anyone figured out a safe/suitable/clever way to get the new lines (pitot and signal) out through the wing to the new pitot?
Thanks!
Lee...