Seansull
Active Member
I am working on my first avionics install and have encountered a problem that I have been unable to solve.
I can't control the V6 from iEFIS. V6 is working properly stand alone and so is iEFIS. I have verfied that TX to RX wiring on all RS232 ports is correct. Everything has power and is grounded as per wiring diagrams.
iEFIS RS232 Port 1 goes to VPX Sport
iEFIS RS232Port 2 goes to extender
iEFIS/Extender RS232 Port 3 goes to V6 RS232 Port 1
Extender and COM1 are enabled on iEFIS
Any input is greatly appreciated.
I have installed iEFIS Lite (latest firmware updated)
Extender module
V6
I can't find any settings on the V6 to allow remote access.
Thanks in advance!
Sean Sullivan
I can't control the V6 from iEFIS. V6 is working properly stand alone and so is iEFIS. I have verfied that TX to RX wiring on all RS232 ports is correct. Everything has power and is grounded as per wiring diagrams.
iEFIS RS232 Port 1 goes to VPX Sport
iEFIS RS232Port 2 goes to extender
iEFIS/Extender RS232 Port 3 goes to V6 RS232 Port 1
Extender and COM1 are enabled on iEFIS
Any input is greatly appreciated.
I have installed iEFIS Lite (latest firmware updated)
Extender module
V6
I can't find any settings on the V6 to allow remote access.
Thanks in advance!
Sean Sullivan
Last edited: