I received my P-Mag today and was planning on installing it this week. I pulled the right slick mag and pulled the gear off but when I try install it on the P-Mag, it seems it goes in too easy and the when the nut is tight to the spec (125-150 in/lb.) the shaft stick out beyond the gear by about at least 1/8? and I was wondering if this is OK. If my understanding is correct, there is not much clearance between the gear and the case of the engine inside. Also when I undo the castle nut, the gear comes out easily with hardly any pressure as the one on the slick Mag was very tight and required a pulley puller to get it off.
Which washers did you guys use, as there are two provided in the kit and the original Slick has one thick washer.
Which washers did you guys use, as there are two provided in the kit and the original Slick has one thick washer.