Hiya Guys/gals,
I am upto step 9 on page 10-09 riviting the F1280 to the lower skin being F1281. However as I cleco it together it looks as though there will be an edge left after rivet. The edge I am concerned about is shown in Figure 2 where the arrow for F-1280-L is pointing.
Did anyone else concern themselves with this? Should I consider creasing the 1280 skins slightly? Or does it pull up ok?
Thanks in advance to any offerings of advice.
Jim Tatlock
Geelong Australia.
I am upto step 9 on page 10-09 riviting the F1280 to the lower skin being F1281. However as I cleco it together it looks as though there will be an edge left after rivet. The edge I am concerned about is shown in Figure 2 where the arrow for F-1280-L is pointing.
Did anyone else concern themselves with this? Should I consider creasing the 1280 skins slightly? Or does it pull up ok?
Thanks in advance to any offerings of advice.
Jim Tatlock
Geelong Australia.