jrock836
Well Known Member
I'm trying to put my RV12 back together after much disassembly to install my ADSB-IN... I had to unbolt the Flaperon Mixer Bellcranks in order to run the coax under all the pushrods and bellcranks and drill some holes. I spent almost 4 hours earlier trying to line up everything including that dang washer on the bottom in order to slide the bolt in through 6 different holes... No joy... As anyone who has done this before knows, there are lots of restrictions that make working in that area VERY difficult. I finally decided I needed to just walk away from it for awhile before tools started flying..
I'm about to head back for round #2 right now. I just thought I would see how other people managed to get it done. I'm planning to use a very small spot of super glue to hold the washer in place and see if that will work. Anyone else have any other brilliant solutions? I will check for any posts once I get to the hangar. Hopefully someone has a better way. I already tried to stick the washer in place with Easy Turn, but that didn't work. Washer kept moving around as I lined up everything else... UGGG...
I'm about to head back for round #2 right now. I just thought I would see how other people managed to get it done. I'm planning to use a very small spot of super glue to hold the washer in place and see if that will work. Anyone else have any other brilliant solutions? I will check for any posts once I get to the hangar. Hopefully someone has a better way. I already tried to stick the washer in place with Easy Turn, but that didn't work. Washer kept moving around as I lined up everything else... UGGG...
Attachments
Last edited: