Junglepilot
Well Known Member
Gear towers going in and last check finds that the F802c (The top-plate on the gear tower assembly) and it's overlap of the F887 [top] longeron doesn't "look like the picture" so to speak, in my plans.
With a little pressure I can pull it over maybe an 1/8".
These are all pre-punched -1 parts, so I didn't mis-drill anything.
Anyone else had this happen? Any ideas? Suggestions?
Here is photo of the left side to give you an idea.
Thanks....
With a little pressure I can pull it over maybe an 1/8".
These are all pre-punched -1 parts, so I didn't mis-drill anything.
Anyone else had this happen? Any ideas? Suggestions?
Here is photo of the left side to give you an idea.
Thanks....
![F802C_Topplatefit.jpg](/proxy.php?image=http%3A%2F%2Fwww.junglepilot.org%2Fwp-content%2Fuploads%2F2010%2F02%2FF802C_Topplatefit.jpg&hash=7f7da0b533174e2c6a2fcddd39e77913)
Last edited: