hgerhardt
Well Known Member
Installed ver. 8 software into my almost-flying 2-screen G3X/GSU73/GTN650 system and found what I think is a software bug...
Trying to perform the Pitch/Roll Offset calibration. Select Pitch/Roll Offset and press Enter, and it performs the cal, as it should, then after a few seconds, it reports SUCCESS, then at the bottom of the page is the DONE button, which takes you back to the previous page. On this page, it reports that the test is NOT DONE. Tried several times and got the same result.
Anyone else tried this yet?
Trying to perform the Pitch/Roll Offset calibration. Select Pitch/Roll Offset and press Enter, and it performs the cal, as it should, then after a few seconds, it reports SUCCESS, then at the bottom of the page is the DONE button, which takes you back to the previous page. On this page, it reports that the test is NOT DONE. Tried several times and got the same result.
Anyone else tried this yet?