Just over 6 hours total time and my G3X touch PDF has gone dark!
Yesterday I was flying the test card procedures and all was great. After landing I shut down and realized I hadn't remember to write down the hours from the display, so I turned it back on and the PDF failed to light light up! The MFD came to life as usual and that is where the data was that I was after.
I pulled the PFD out and checked the Stein assembled connectors and all seemed normal (no connectors were pushed back in the shell). I then pulled the MFD and swapped positions The MFD still lit up fine on the left side but the PFD was still dark on the co-pilot side.
I don't know what else I might check to troubleshoot the problem so I have an email off to Van's for guidance.
Any ideas what else I can try?
Yesterday I was flying the test card procedures and all was great. After landing I shut down and realized I hadn't remember to write down the hours from the display, so I turned it back on and the PDF failed to light light up! The MFD came to life as usual and that is where the data was that I was after.
I pulled the PFD out and checked the Stein assembled connectors and all seemed normal (no connectors were pushed back in the shell). I then pulled the MFD and swapped positions The MFD still lit up fine on the left side but the PFD was still dark on the co-pilot side.
I don't know what else I might check to troubleshoot the problem so I have an email off to Van's for guidance.
Any ideas what else I can try?