jamesdavid
Member
Hello,
I recently did a full panel upgrade to add a dual G3X (460, 470), GNC255, GNX375, GMC307, GEA24, GAD29, and G5.
My system powers up, but after a couple minutes gives me errors:
"Not receiving data on ARINC 429 channel 1" and
"Not receiving data on ARINC 429 channel 2".
The GNX 375 is connected to GAD29 via Channel 1 for GPS.
The GNC 255 NAV is connected to GAD29 via Channel 2 for VOR/ILS.
Pictures and video below...
(All of the equipment was purchased new from Stein with the exception of the GNX375 which was purchased new from SarasotaAvionics.)
Install was done by a local shop wiring has been checked, and checked again.
Software is most recent versions for G3X and LRUs (8.72) and GNX375 (3.10).
I have been in contact with g3xpert since July, and the avionics shop has been talking with them since before that. Still no resolution to date although g3xpert is still trying to help...
- Wiring has been repeatedly checked.
- Most recent software installed.
- Configuration verified on G3X, GNX, and GNC.
Has anyone else experienced anything similar? Resolved the situation?
Video of Issue: https://www.youtube.com/watch?v=B3TTDZudsZg (everything appears to be functioning until the ARINC 1&2 message appears at 2:00 into the video)
Configuration Pictures:
I recently did a full panel upgrade to add a dual G3X (460, 470), GNC255, GNX375, GMC307, GEA24, GAD29, and G5.
My system powers up, but after a couple minutes gives me errors:
"Not receiving data on ARINC 429 channel 1" and
"Not receiving data on ARINC 429 channel 2".
The GNX 375 is connected to GAD29 via Channel 1 for GPS.
The GNC 255 NAV is connected to GAD29 via Channel 2 for VOR/ILS.
Pictures and video below...
(All of the equipment was purchased new from Stein with the exception of the GNX375 which was purchased new from SarasotaAvionics.)
Install was done by a local shop wiring has been checked, and checked again.
Software is most recent versions for G3X and LRUs (8.72) and GNX375 (3.10).
I have been in contact with g3xpert since July, and the avionics shop has been talking with them since before that. Still no resolution to date although g3xpert is still trying to help...
- Wiring has been repeatedly checked.
- Most recent software installed.
- Configuration verified on G3X, GNX, and GNC.
Has anyone else experienced anything similar? Resolved the situation?
Video of Issue: https://www.youtube.com/watch?v=B3TTDZudsZg (everything appears to be functioning until the ARINC 1&2 message appears at 2:00 into the video)
Configuration Pictures:
Last edited: