pilotshive
Member
This is a two part post...
First, I am finally back to chipping away at my RV-8QB wings (after a long hiatus due to an overseas deployment followed by the addition of an ATP and type rating). I next plan on tackling the final wing skin and installing the fuel floats over the next week before I go back out of town for a couple months. Because this is a QB kit (fuel tank already sealed) I can't figure out how to check the travel/clearance of the float before final installation... any tips on this?
Second, is there anyone on the forum who would be interested in helping me attach the final wing skins? I'm located in Harrisonburg, VA. I need help with this last skin as it has been holding me up... I can't seem to get experienced help.
Thanks!
J
First, I am finally back to chipping away at my RV-8QB wings (after a long hiatus due to an overseas deployment followed by the addition of an ATP and type rating). I next plan on tackling the final wing skin and installing the fuel floats over the next week before I go back out of town for a couple months. Because this is a QB kit (fuel tank already sealed) I can't figure out how to check the travel/clearance of the float before final installation... any tips on this?
Second, is there anyone on the forum who would be interested in helping me attach the final wing skins? I'm located in Harrisonburg, VA. I need help with this last skin as it has been holding me up... I can't seem to get experienced help.
Thanks!
J