First start today, woohoo!
Fairly uneventful except there was an odd CHT/EGT issue on #3.
In the first 10-15 seconds the CHT shot up to 1000 degrees then a big red X appeared.
The EGT never went above 400 #3.
All the others leveled right out as expected.
The physical temps by touch were about the same for #3 as the others, didn't have a temp gun with me.
If it was just one of the sensors I would think just a bad sensor/wiring problem but both is throwing me off.
Does anyone have any suggestions or ideas before I start troubleshooting?
Not very helpful but here's a pic after I shut it down and was cooling, the sensor recovered, didn't think to take a pic while it was running.
Fairly uneventful except there was an odd CHT/EGT issue on #3.
In the first 10-15 seconds the CHT shot up to 1000 degrees then a big red X appeared.
The EGT never went above 400 #3.
All the others leveled right out as expected.
The physical temps by touch were about the same for #3 as the others, didn't have a temp gun with me.
If it was just one of the sensors I would think just a bad sensor/wiring problem but both is throwing me off.
Does anyone have any suggestions or ideas before I start troubleshooting?
Not very helpful but here's a pic after I shut it down and was cooling, the sensor recovered, didn't think to take a pic while it was running.
![oEd.jpg](/proxy.php?image=http%3A%2F%2Fhalie.com%2Fscale%2F15%2FoEd.jpg&hash=1fa49c03fc6ed0b03d8e60ed0f1a9dab)