On page 8-30 of the new 8 pre punched fuse kit the plans call for machine counter sinking the F-843 lower longerons in 5 places to accept dimples on the F-822 fwd. floor panel.
After doing so I can't see a reasonable way to dimple the 2 hole for and 2 holes aft of the l/g box towers.
Has anybody else run into this problem?
Were the plans wrong and perhaps the floor panel should have been machine c/s instead?
Steve
After doing so I can't see a reasonable way to dimple the 2 hole for and 2 holes aft of the l/g box towers.
Has anybody else run into this problem?
Were the plans wrong and perhaps the floor panel should have been machine c/s instead?
Steve