Not sure if this belong here or over in the -4 group, please move if needed.
I'm picking up on a -4 project that never got completed. At one point an engine was mounted and the cowl was fitted. I bought the project with no engine or prop and have since built up a IO-360 for the project. I was just about to mount the engine and noticed the Barry mounts that came with the project have a thick additional washer on two of the mounts. I assume these "spacers" were used when the original engine was mounted and the cowl was fitted. So now I'm left wondering how to proceed with hanging my engine. Should I just hang it with no spacers and see how the cowl fits? Any advice would be appreciated.
Thanks
Shawn
I'm picking up on a -4 project that never got completed. At one point an engine was mounted and the cowl was fitted. I bought the project with no engine or prop and have since built up a IO-360 for the project. I was just about to mount the engine and noticed the Barry mounts that came with the project have a thick additional washer on two of the mounts. I assume these "spacers" were used when the original engine was mounted and the cowl was fitted. So now I'm left wondering how to proceed with hanging my engine. Should I just hang it with no spacers and see how the cowl fits? Any advice would be appreciated.
Thanks
Shawn