jdeas
Well Known Member
Reading the rebuild manual it appears the 1/4" bolts around the edge of the case halves should be torqued to 75 in/lbs in a pattern when joining.
Standard torque is ~95 in/lbs unless otherwise listed in the manual and while most special torques are listed in the rebuild manual I can't find this one. Can someone clarify if these bolts stay at 75 inch/lbs or get increased to standard torque value?
Thanks for the correction Mike!
Standard torque is ~95 in/lbs unless otherwise listed in the manual and while most special torques are listed in the rebuild manual I can't find this one. Can someone clarify if these bolts stay at 75 inch/lbs or get increased to standard torque value?
Thanks for the correction Mike!
Last edited: