Toobuilder
Well Known Member
Help!
I?ve replaced the stand-alone Ray Allen trim and flap indicators in favor of those available on the GRT display. I am using Analog 5, 6, and 7 for pitch, flap and roll, and have gone into the setup page to enable this function. So far, so good. However, they are not showing any movement (or the ?pointer? for that matter) when I run the trim. I am fairly certain that since these analog inputs are pretty generic in nature (only looking for a voltage input), then I have to "train" them to know where the travel limits are for the installed equipment. So how are these calibrated? I can?t seem to find any mention of this procedure in the manuals I have ? what?s the secret?
Thanks a million
I?ve replaced the stand-alone Ray Allen trim and flap indicators in favor of those available on the GRT display. I am using Analog 5, 6, and 7 for pitch, flap and roll, and have gone into the setup page to enable this function. So far, so good. However, they are not showing any movement (or the ?pointer? for that matter) when I run the trim. I am fairly certain that since these analog inputs are pretty generic in nature (only looking for a voltage input), then I have to "train" them to know where the travel limits are for the installed equipment. So how are these calibrated? I can?t seem to find any mention of this procedure in the manuals I have ? what?s the secret?
Thanks a million