I have a FT60 fuel flow transducer mounted in my RV but get constantly 0 reading in the Dynon HDX.
The transducer is connected to the EMS-220 with the correct pins (13, 14, 15) but I measure only 7,95V on the red cable comming from pin 15.
According to the instruction it supoused to give 12V !? I figure thats the reason the transducer is not working at all .
Has any of You had such problem ? What voltage do You measure at the transducer ?
The transducer is connected to the EMS-220 with the correct pins (13, 14, 15) but I measure only 7,95V on the red cable comming from pin 15.
According to the instruction it supoused to give 12V !? I figure thats the reason the transducer is not working at all .
Has any of You had such problem ? What voltage do You measure at the transducer ?
