rdamazio
Well Known Member
So far my countersinks have been pretty good, round and precise. I just started countersinking E-1007 on my -10 kit, and with the same technique got these results:
So I'm wondering - what's going wrong here? Why did this start happening only now, with so many previously-successful countersinks? Could it be that my tool (cage, bit or drill) needs replacement? Am I missing something obvious? (I do not have Parkinson's disease )
Also, I assume this part is now trash and I should order a new one? The holes look too large even for oops rivets (but on the other side, this part is sandwiched between two others - the hinge that holds the trim tab and the skin).
So I'm wondering - what's going wrong here? Why did this start happening only now, with so many previously-successful countersinks? Could it be that my tool (cage, bit or drill) needs replacement? Am I missing something obvious? (I do not have Parkinson's disease )
Also, I assume this part is now trash and I should order a new one? The holes look too large even for oops rivets (but on the other side, this part is sandwiched between two others - the hinge that holds the trim tab and the skin).